Table of Contents
Advertisement
Installing the batteries in the remote control
Install the batteries (R6/AA x2) matching the
polarity indicated inside battery compartment
of the remote control.
1
Open the cover.
2
Insert batteries.
•
Make sure to match
batteries to the marks indicated in the
battery compartment.
3
Close the cover.
Note
•
Incorrect use of batteries can result in hazards such
as leakage and bursting.
+and - on the
Using a Remote Control
Keep in mind the following when using the
remote control:
•
Make sure that there are no obstacles
between the remote control and the
infrared sensor window on the unit.
•
Remote operation may become unreliable if
strong sunlight or fl uorescent light is shining
on the infrared sensor window of the unit.
•
Remote control for different devices can
interfere with each other. Avoid using
remote control for other device located
close to the unit.
•
Replace the batteries when you notice a fall
off in the operating range of the remote
control.
•
The maximum operable ranges from the
unit are as follows.
Line of sight:
•
approx. 7m (23 feet)
Either side of the centre:
•
(16 feet) within 30°
•
Above:
approx. 5m (16 feet) within 15°
•
Below:
approx. 3m (10 feet) within 30°
approx. 5m
30˚
30˚
5m (16 feet)
7m (23 feet)
5m (16 feet)
EN
13
Advertisement
Table of Contents
