Instructions For Assembly - Invacare Flo-tech PT Anti-Thrust Harness Fitting Instructions Manual

STEP 1—Remove Anti-Thrust Harness
and components from the packaging.
STEP 2— Should this product reach you
in an unsatisfactory condition, please
contact the supplier.
STEP 3—When properly installed, the
user will be sitting on the wide portion of
the harness (see fig. 1). To install, lay
the Anti-Thrust Harness on the
wheelchair seat. The back of the
harness should be at the back of the
seat (see fig. 1). Attach the rear tri slot
mounting plates (see fig. 2) into the
desired position on the wheelchair frame
using the Universal Mounting Clamps,
which are suitable for round tube frames
of 19mm, 22mm, and 25mm (see fig. 3).
STEP 4 – Position the user on the
harness with the front padded straps
wrapping over the legs (see fig. 4).
Attach the front tri slot mounting plates
on the front straps of the harness into
the desired position on the wheelchair
frame using the Universal Mounting
Clamps, which are suitable for round
tube frames of 19mm, 22mm, and 25mm
(see fig. 3).
It is recommended that all screws be
tightened to 8.5Nm.
Flo-tech PT Anti-Thrust Harness
Fitting Instructions

INSTRUCTIONS FOR ASSEMBLY

3 3
INSTRUCTIONS
FOR ASSEMBLY
Figure 1
Figure 2
Figure 3
Level with rear
of wheelchair
seat