Product Installation - Key Automation SN-50 Instructions And Warnings For Installation And Use

4 - PRODUCT INSTALLATION

4.1 - Installation
e ore start the sta at o
a d that the acka co ta s a the com o e ts show .
Make sure that the mou t
d me s o s . .
heck the a owed o e a
brackets . a d the d a ram
. s a e am e o a ty ca system
erators
hotoce s
osts or hotoce s
ash ht w th te rated aer a
ey or d ta sw tch
Mounting the motor bracket to the pillar
e ter the ar bracket ssa do
bracket us su tab e screws a d washers
4.2 - Adjusting the limit switch (230 Vac version)
screw the cover screws.
oose the screws to ad ust the e ectr ca m t sw tches u t you are
4.3 - Electrical connections
sert the su y cab e to the term a . o
4.4 - Mechanical and electronic connections of the second motor
case o sta at o o the seco d motor
me t o ed struct o s or the mecha ca mou t
make sure that the roduct s
area s com at b e w th the overa
e accord to the o ts o the
. .
rev ous y traced by
ot su ed
ect the w res o the su
o ow the above
aste the motor to the
tact
su ed. ur
aligned.
ATTENTION: an off-axis mounting can cause malfunctioning
and damage the automation system.
Mounting the motor bracket
Move the ate ea u to the ma mum o e
Release the gearmotor.
ace the arm c ose to the ea a d ay o the ea the ate bracket
ho d w th o e ha d the bracket
make a com ete o e
aste the ate bracket to the ea w th su ted screws
ed .
aste the motor arm to the bracket.
Important: make sure that the bracket and the gate arm are
perfectly aligned.
the
ATTENTION: a not aligned mounting can cause malfunctioning
. .
and damage the automation system.
able to scroll.
crew the des red os t o .
y cab e to the term a o ow
e ectr ca co ect o s re er to the
or the
ar bracket w th the screws a d uts
th s hase make sure that the motor s er ect y
co tact w th the ea try to
a d c os moveme t.
the e ectr ca draw
. .
EN
os t o .
ot su -
. .
11