Table of Contents
Advertisement
Just for Kids - Ring Frame to Uprights Assembly
This procedure will require at least two (2) qualified
persons. At no time should children or other unqualified
persons undertake any part of this procedure.
1. Locate one (1) Upright Assembly (#355-05).
Note: See Page 8, Pre-assembly of collapsible JFK
Uprights, if this step was missed.
2. Install the Upright Assembly between the Base Assemblies
(refer to section on Base Assemblies Tie-Down if required)
tighten the clamp (FIG 9) on the lower section of each side of
the Upright Assembly by turning Clockwise.
Note: Mounting the Upright Assembly on to the Base
Assemblies must be done at this time in order to
prevent the completed assembly from toppling over.
3. Loosen the Spin-Snap Lock on each side of the Upright
Assembly by turning the Spin Lock portion, round disc,
counterclockwise. Turn the handle counterclockwise until it
stops, but do not force it any further. This stop prevents the
Spin Lock from being removed.
4. Working with one Ring Frame at a time, prepare to slide the Ring Frame Assembly
into the Upright Assembly. (See FIG 9) The 5 locking holes in the Ring Frame
Assembly must face to the outside of the Uprights. Ensure that the Ring Frame
Assembly is at right angles to and rotated to align properly with the Upright Tubes.
5. Release the Snap Lock Device on each Upright and lower the Ring Frame
Assembly into the Uprights. Pull outward on the Snap Lock Device once the Inner
Tube reaches the pin, lower the inner tube while releasing the locking device until
st
the 1
inner tube hole allows the pin to fall into the locking hole of the inner tube,
the Snap Lock Device is now engaged.
Note: To avoid injury while lowering the Ring Frame into position, keep hands
well clear of the inner tubes where they slide into the Uprights.
6. Position the Ring Frame Assembly at a height that will be comfortable to work with
during the set-up of the apparatus and engage the Snap Lock Devices so that the pin
drops into a hole. Tighten the Spin Lock portion securely by turning it clockwise.
7. Repeat Steps 4 through 6 with the second Ring Frame Assembly.
Just for Kids -Attaching Rings to Ring Frame Assembly
1. Locate the Ring Assemblies (#355-110).
2. Open the quick links on the Ring Assemblies and mount them to
the Ring Frames. Close the quick links securely. (See FIG 10)
JFK Product & Installation Instructions #8920100 Feb 2, 2015
FIG 10
Pg. 17
FIG 9
Advertisement
Table of Contents
