Table of Contents
Advertisement
Just for Kids - Rail to Inner Tube Assembly
This procedure will require at least two (2) qualified
persons. At no time should children or other
unqualified personnel undertake any part of this
procedure.
The length of the inner tube assemblies you are working with
will vary depending on the Just for Kids product that you are
assembling. However, the procedure for assembling rails and
inner tube assemblies is same for all products.
1. Locate one (1) rail and two (2) inner tube assemblies.
Note: If you are assembling Just for Kids Uneven
Bars, ensure that the inner tube assemblies
you select are equal in length when
assembling each of the 2 rail heights.
2. Remove the Nylock Nuts and mounting Bolts from the rail
U-bracket located on the end of each rail.
3. Working with one (1) Inner Tube Assembly at a time, place
the rail pivot, which is located at one end of the Inner Tube
Assembly, into the U-bracket. See FIG 7
4. Align the hole in the rail pivot with the one in the U-
bracket and insert the mounting Bolt through these holes. Install
the Nylock nut with the nylon ring facing away from the U-
bracket.
5. Tighten the Nylock & bolt snug, but don't over
tighten, a small space between the U-brackets
and rail pivot allow for the bar to flex, see fig 7.
Note: When tightening the nut and bolt
the Nylon Ring in the Nylock nut
must be past the end of the threads
of the bolt to ensure that the nut
won't come loose.
6. Repeat steps 3 to 5 with a second Inner Tube
Assembly at the opposite end of the Rail.
7. If you are assembling Just for Kids Parallel Bars
or Uneven Bars, repeat Steps 1 through 6 with
the other Rail and Inner Tube assemblies.
JFK Product & Installation Instructions #8920100 Feb 2, 2015
FIG 7
Pg. 14
Advertisement
Table of Contents
