Table of Contents
Advertisement
Just for Kids - (355-01) Base Assemblies Tie-Down
S/A Sport recommends that the Base Assemblies be bolted to the floor.
They have been designed and supplied with the required hardware for
bolting to a concrete floor.
This procedure will require at least two (2) qualified
persons. Children or other unqualified personnel should at
no time undertake any part of this procedure.
1. Position the apparatus in the desired location. Align both Base Leg assemblies (355-01) as shown in FIG 1.
Ensure that the numbers on the side of the bases, the adjustment scale face away from centre.
2. Install 1 or 2 JFK upright assemblies (355-05) between the 2 (355-01) Base Assemblies (FIG 1), Tighten the
clamp (FIG 1A) on the lower section of each side of the "JFK" (355-05) Uprights by turning Clockwise, this
will assist in maintaining the correct width and alignment.
Note: The Base Assemblies must be parallel to each other to allow for proper and complete
horizontal adjustment of the Uprights along the length of the Base Assemblies.
Note: Never place a floor anchor into a crack, or an area within 9" from a crack or into the edge of
the concrete.
Note: Install "JFK" Upright Assemblies onto Bases before
drilling Anchor holes.
Use diagonal Measurements (99 7 8 ") to help square up
bases, when measured the two diagonal distances
should be approximately the same.
FIG 1
JFK Product & Installation Instructions #8920100 Feb 2, 2015
9
8
7
7
Pg. 10
FIG 1A
8
9
Advertisement
Table of Contents
