Table of Contents
Advertisement
9
CLEANING THE INLET HOSE AND THE VALVE FILTER
1
1
2
3
FROST PRECAUTIONS
If the appliance is installed in an area where the
temperature can be less than 0° C, remove the
remaining water from the inlet hose and the drain
pump.
1. Disconnect the mains plug from the mains
socket;
2. Close the water tap;
3. Unscrew the water inlet hose from the tap;
4. Unscrew the water inlet hose from the back
appliance;
5. Place the two ends of the inlet hose in a bowl
and let water flow out of the hose;
6. Set the drain programme and let it operate until
the end of the cycle.
7. Turn the programme knob to
the appliance from the power supply.
8. When the drain pump is empty, install the
water inlet hose again.
WARNING! Make sure that the
temperature is more than 0 °C before
you use the appliance again.
The manufacturer is not responsible
for damages caused by low
temperatures.
TROUBLESHOOTING
WARNING! Refer to Safety chapters.
14
2
to disconnect
3
EMERGENCY EMPTYING OUT
If the appliance does not drain the water, to empty
out proceed as follows:
1. Disconnect the mains plug from the mains
socket;
2. Close the water tap;
3. If necessary, wait until the water has cooled
down;
4. Open the filter door;
5. Place a bowl on the floor below the recess of
the drain filter;
6. Press the two levers and pull forward the
drainage duct to let the water flow out;
The water should drain by gravity into the bowl.
7. When the bowl is full of water, put the drainage
duct back again and empty the bowl;
8. Repeat the procedure until water stops flowing
out;
9. If necessary, clean the pump as previously
described;
10. Put the drainage duct back;
11. Close the drain filter door.
INTRODUCTION
The start of the appliance does not occur or it
stops during operation.
4
45°
20°
Advertisement
Table of Contents
