Dyna-Glo DGP321SNN Manual page 12

ASSEMBLY INSTRUCTIONS
11. Carefully place the grill body (C) onto cart left
side panel assembly (L) and cart right side
panel assembly (G). Adjust the grill body (C)
so that the holes in the grill body (C) are
aligned with holes in the tabs of cart left side
panel assembly (L) and cart right side panel
assembly (G).
Note: Make sure the natural gas hose is inside
the cart. Secure the grill body (C) with four
M6X16 screws (AA).
Hardware Used
AA
M6x16 Bolt
12. Pre-assemble two M6x16 bolts (AA) onto the
cart right side panel assembly (G) and do not
tighten them. Make sure to leave a 5mm gap
between the bolt and the panel. Hang the
natural gas hose bracket onto the bolts and
tighten the two bolts. Put two pieces natural
gas hose holders (Y) in to the hose. Attach the
natural gas hose holders (Y) to the bottom shelf
(J) with two M4x12 bolts (JJ). NOTE: Make sure
the natural gas hose exits through the hole in
the cart rear panel (W).
Hardware Used
AA
M6x16 Bolt
JJ
M4x12 Bolt
11
Hardware Used
AA AA
M6x16 Bolt x4
x 4
12
x 2
x 2
12
G
J
Y
Y
W
C
C
AA
AA
G
AA
5mm
JJ
Y