Table of Contents
Advertisement
Speakers
•
Output power: 2 x 150W RMS (30% THD)
•
Speaker impedance: 6 ohm
•
Drivers per speaker: 2 x 64 mm (2.5") full
range woofer + 1 x 64 mm (2.5") woofer +
1 x 25.4 mm (1") soft-dome tweeter
•
Frequency response: 150 Hz-20 kHz
•
Dimensions (WxHxD): 99 x 247 x 117 mm
•
Weight: 1.4 kg/each
•
Cable length: 5 m
Remote control batteries
•
2 x AAA-R03-1.5 V
EN
18
10 Troubleshooting
Warning
•
Risk of electric shock. Never remove the casing
of the product.
To keep the warranty valid, never try to repair the
product yourself.
If you have problems using this product, check the
following sections before you request service. If
you still have a problem, register your product and
get support at www.philips.com/welcome.
Sound
No sound from SoundHub.
•
Make sure that the SoundHub is not muted.
Press to select MUTE OFF on the display
panel.
•
Connect the audio cable from your SoundHub
to your TV or other devices.
•
Reset your SoundHub to its factory settings,
and then switch it off and switch on again.
•
On your remote control, press AUX,
COAXIAL/OPTICAL, or MUSIC iLINK
repeatedly to select the correct audio input on
the display panel (see 'Listen to a connected
device' on page 8).
Distorted sound or echo.
•
If you play audio from the TV through the
SoundHub, make sure that the TV is muted.
Audio and video are not synchronized.
•
1) Press AUDIO SYNC. 2) Within two seconds,
press the Navigation buttons (
change the delay shown on the display panel. 3)
Press AUDIO SYNC again to exit.
Play
AirPlay icon does not appear in iTunes.
•
Make sure that the AirPlay device is connected
to the same network as the SoundHub.
•
Make sure that the network connection is
connected successfully.
•
Restart the iPod (iPod) application on your
Airplay device.
Break AirPlay music streaming frequently.
•
Make sure that the Auto channel scan option
is enabled (if available on the Wi-Fi router).
/
) to
Advertisement
Table of Contents
