Display panel
Change the brightness of the SoundHub display
panel.
1
Press SETUP repeatedly to select DISPLAY
on the display panel.
2
Press OK.
3
Press the Navigation buttons (
select BRIGHT, DIM 1, or DIM 2, and then
press OK.
Sleep timer
Set timers to switch the SoundHub to standby
after a specified time.
1
Press SETUP repeatedly to select SLEEP on
the display panel.
2
Press OK.
3
Press Navigation buttons (
sleep time on the display panel.
» The sleep timer can be set up to 60
minutes. If the sleep timer is set to OFF, it
switches off.
Note
•
If you switch the SoundHub to standby, the sleep
time that you have set is canceled.
IP address
Check the IP address if the SoundHub is
successfully connected to the network.
1
Press SETUP repeatedly to select IP ADDR
on the display panel.
2
Press OK.
» The current IP address is displayed.
Note
•
If the network connection fails or not yet
connected, NO CONNECTION is displayed
when IP ADDR is selected.
EN
16
/
) to
/
) to set a
Apply factory settings
You can reset your SoundHub to the default
settings programmed at the factory.
1
Press SETUP repeatedly to select RESET
DEFAULT SETTINGS on the display panel.
2
Press OK.
» TO RESET PRESS OK is displayed on
the display panel.
3
Press OK again.
» When the default settings are restored,
RESET OK is displayed on the display
panel, and the SoundHub automatically
switches off and restarts.