Table of Contents
Advertisement
Caution
•
Before you try to connect the SoundHub to
a computer network, familiarize yourself with
the network router, media server software,
and network principles. If necessary, read
documentation that accompanies the network
components. Philips is not responsible for lost,
damaged, or corrupt data.
What you need
•
A wireless network router.
•
An AirPlay enabled device:
•
iOS 4.3 and above on iPhone, iPod touch,
or iPad.
•
iTunes 10.2 or later on Wi-Fi enabled
computer.
Before you start
•
Make sure that the wireless router is
switched on and works properly.
•
Check the type of wireless router you use.
Some operations may vary when different
types of wireless routers are used.
Connect SoundHub to a Wi-Fi network
Depending on the type of the router, connect your
SoundHub to the Wi-Fi network in one of the
following ways.
The SoundHub automatically connects to the last
used Wi-Fi setup every time it is switched on.
Option 1: Connect SoundHub to a WPS
router
Wi-Fi protected setup (WPS) enables you
to connect devices to your router without a
password. Simply enable the WPS function on
both the router and your SoundHub and they
are connected. Most of the WPS router carry the
WPS logo: .
1
Press and hold SETUP for five seconds to
switch to the WPS mode.
» PRESS WPS BUTTON ON ROUTER
AND WAIT is displayed on the display
panel.
» The subwoofer LED indicator blinks
continuously.
2
Within ninety seconds, press the WPS button
once on the router.
3
When the connection with the router is
established, WPS SUCCESS is displayed on
the display panel.
4
When the SoundHub joins the Wi-Fi
network successfully, READY FOR AIRPLAY
is displayed on the display panel.
» The subwoofer LED indicator stops to
blink and stays white.
5
If the connection fails or you are unable to
press the WPS button on the router within
ninety seconds, WPS FAILED is displayed on
the display panel. Repeat steps 1 to 4 again.
Note
•
To enable AirPlay, make sure that your AirPlay
device is connected to the same network as the
SoundHub.
Option 2: Connect SoundHub to a non
WPS router
Connect your SoundHub to a non WPS router
through an AirPlay enabled device.
1
Press SETUP repeatedly to select WIFI on
the display panel.
2
Press OK.
3
Press the Navigation buttons (
select BROWSER SETUP, and then press
OK.
» First, PLEASE WAIT is displayed on the
display panel and the subwoofer LED
indicator blinks continuously.
» Then, the SoundHub creates a virtual
network and SELECT PHILIPS
AIRPLAY NETWORK AND BROWSE
192.168.1.12 is displayed on the
display panel. When you connect your
AirPlay enabled device to this network,
you can access the SoundHub setup
web page.
4
On your iPod Touch, iPhone or iPad, select
Settings > Wi-Fi.
•
On your Wi-Fi enabled computer, select
the list of available wireless networks.
/
) to
EN
9
Advertisement
Table of Contents
