XO I/O Interface USB Module – Technical Manual
To connect and map the XO I/O Interface USB modules, proceed as follows:
1.
If you have not done so already, log on to the hardware configuration tool.
2.
Connect the XO I/O Interface USB module to the XO device using the provided USB cable: insert one end
into the module, and the other end into a free USB port on the XO device.
Note
If you are using a double module, Xtralis recommends to connect and map each module
separately. Because the modules all appear with the same name in the Product column
(MIO CARD), this will prevent incorrect mapping.
3.
In the hardware configuration tool, click Refresh. The module will now appear in the list, with the Device
Node column empty.
The example below shows a device that already has a first set of MIO/EIO cards: MIO-1 is already
configured. The row above (- - -) indicates the newly connected module that needs to be mapped.
14
ADPRO
32688_02