Installation; Rubber Feet; Logging On To The Hardware Configuration Tool - Xtralis ADPRO 49840600 Technical Manual

XO I/O Interface USB Module – Technical Manual
2

Installation

2.1

Rubber Feet

Attach the included self-adhesive rubber feet to the bottom of the module.
2.2

Logging on to the Hardware Configuration Tool

You need to log on to the hardware configuration tool using the XO Technician user. For this, you need to:
1. Enable the Technician user using the XO client software.
2. Generate a special, temporary access code (PIN of the day) for the Technician user. The PIN limits the time
that the Technician user has access to the configuration tool.
Note
You cannot log on to the hardware configuration tool while the XO device is restarting.
To log on to the hardware configuration tool, proceed as follows:
1. Open the XO client, and log on to the desired XO device as an Administrator.
2. Choose System > General > Users.
3. Under Technician grant, click Enable.
4. Under Technician pin of the day code, click Pin of the day. The following window appears:
10
ADPRO
32688_02