Gate Access (Wireless) - Chamberlain MyQ Business CAPXL Installation Manual

INTRODUCTION

Gate Access (Wireless)

The CAPXL can communicate wirelessly to LiftMaster
send email notifications if an error occurs in the operator (email notifications are configured in myQ
can be paired with the CAPXL - one for each primary and auxiliary relay. If using dual gates, program the CAPXL to the primary operator.
1
Enter Admin Mode
Flip dipswitch #1 to the ON position to
enter Admin Mode.
ON
NOTE: For new installations press
the login button without entering
information in the Admin Username
and Admin Password fields.
4
Press LEARN button on gate
operator again
Press and release the LEARN button
again on the primary operator. The
yellow NETWORK LED will light.
PRE-INSTALL
®
2
Select Outputs and Relay
Select the Outputs tab. Then select the
desired relay on the left-hand side (1
through 4).
ON
5
Select LEARN on display
Select the LEARN button on the
display and the Learn button will go
from blue to red. The gate operator
and the CAPXL will beep once and the
NETWORK LED on the gate operator
will turn off indicating programming is
successful.
NOTE: 4 beeps/blinks indicate you
are not programming to the primary
operator. Reattempt programming
from the other operator.
INSTALL
UL325 2016 gate operators to send open commands, monitor gate position, and
18
NETWORK ACCESS CONTROL
Business™). Up to 8 gate operators
®
3
Press LEARN button on gate
operator
Press and release the LEARN button
on the primary operator. The green
XMITTER LED will light. NOTE: The
operator will time out of programming
mode after 180 seconds.
6
Validate
Validate functionality by selecting Test
Relay on the CAPXL display.
DIAGNOSTICS