Ash Disposal Kit (Ads20) - Napoleon S20-1 Installation And Operation Manual

5.2

ash disposal kit (ADS20)

WARNING
!
• Failure to achieve a good seal between the ash opening and ash plug will result in an over-fi re condition that
could cause damage to the appliance.
Provisions have been made on the appliance to install an optional ash disposal kit. The kit allows for
convenient removal of excess ash.
note:
If the appliance has been previously operated, it must be cold and the ashes must be removed in order to
access the ash plug.
1. Open the ash disposal.
2. From the underside of the appliance, remove the nuts that secure the ash opening cover plate (Fig. 5-3). Discard
cover plate and nuts.
3. Place the ash disposal housing into the ash disposal. Ensure the dimples fi t into the bosses (Fig. 5-4). Close the ash
disposal.
4. Remove the small light weight brick that covers the ash opening and set aside for future use (Fig. 5-5).
note:
It is important that the area around the ash opening be cleaned well to ensure that a proper seal is
created between the new ash plug and the ash opening.
5. Once the area surrounding the opening has been cleaned, place the new ash plug (supplied) over the opening.
Ensure the protrusion on the ash plug is recessed into the opening on the bottom of the fi rebox (Fig. 5-6).
Some parts
hidden
for clarity.
Cover
Plate
Dimples located
under ash disposal
(not illustrated).
Fig. 5-3
Firebox
Opening
Fig. 5-5
optional installation
Boss (x2)
Some parts
for clarity.
Ash Plug
Protrusion located
under ash plug
(not illustrated)
W415-2796 / B / 12.19.19
EN
Fig. 5-4
hidden
Fig. 5-6
25