Electrolux GA60SLVS User Manual page 12

12 www.electrolux.com
Options
XtraDry
ExtraHygiene
Settings
7.2 How to set an option
The option list will show only the options
applicable to the currently selected
programme. Non applicable options are
not visible.
Some options are not compatible with
each other. When you set 2 options that
are not compatible with each other, the
appliance will automatically deactivate one
of the options.
When the programme is completed or is
cancelled the options are set to the default
values.
1. Press the Option key.
2. Select an option.
The display shows the option value
indicated in parenthesis.
3. Press the OK key to change the value
from OFF to ON or vice versa.
If the selected option is Delay start, when
you press the OK key the display shows
the number of hours available for the delay
start. Select the number of hours and
press again the OK key to confirm.
4. To go back to the programme list,
press repeatedly the Option key until
the display shows the selected
programme.
7.3 XtraDry
Activate this option when you want to
boost the drying performance. With use of
this option, the duration of some
programmes, water consumption and the
last rinse temperature can be affected.
Values
ON
OFF (default value)
ON
OFF (default value)
Enter appliance settings
Description
Activate this option if you
want to boost the drying
performance. Refer to spe-
cific information provided in
this chapter.
The use of this option sani-
tizes cutlery and tableware.
During the last rinsing
phase, the temperature
stays at 70 °C for at least
10 minutes.
The XtraDry option is a permanent option
for all programmes other than ECO 50°
and need not to be selected at every
cycle.
Every time ECO 50° is activated, XtraDry
option is off and needs to be chosen
manually. In other programmes, the
setting of XtraDry is permanent and it is
automatically used in next cycles. This
configuration can be changed at any time.
Activating XtraDry option deactivates
TimeSaver.
7.4 TimeSaver
This option increases the pressure and the
temperature of the water.
The washing and drying phases are
shorter. The total programme duration
decreases by approximately 50%.
The washing results are the same as with
the normal programme duration but the
drying results can be less satisfactory.
The TimeSaver option is not applicable to
all programmes.
1. Scroll through the programme list and
select a programme.
2. Press the OK key to confirm.
If the TimeSaver option is applicable to the
selected programme, the display shows
the 2 conditions Fast and Normal and the
programme duration for each condition:
• Fast: TimeSaver activated. Press
the OK key to confirm.