Advertisement
dirty, oxidized, rusted or otherwise compromised. If repair is required, do it before installing the
DX7 DX-MAX(3)+.
2: Installation
Back up your patches if they are important to you!
Open the DX7
Using a Philips head screwdriver, remove the 5 screws from the front panel. Two are located
on the left front. Two are located on the right front. A final one is located on the right rear. Set the
screws aside, noting that the rear panel one is the shortest.
(Re)Move the Keybed & Remove the Keyboard Rail
It can be difficult to see the delicate pins when installing the DX-MAX(3)+ board. By moving the
keybed (the chassis with the keys) and removing the silver keyboard rail, you will have better
sight lines and freedom of movement when installing the DX-MAX(3)+ board.
.
Remove the 4 large external screws from the underside of the keyboard along the front
edge. The photo below shows the inside front edge of the empty case bottom and illustrates the
location of the 4 screws. You will, of course, be unscrewing from the DX7 underside.
Loosen the 3 internal screws at the extreme right and left ends that hold the keybed in
place. It is not necessary to extract them from the holes they reside in.
DX-MAX(3)+
Page 2 of 6
Install v2.00
www.musictechnologiesgroup.com
Preliminary
Advertisement
