On-Site Work (Installation And Wiring) - Yamaha MTX3 Owner's Manual

8. Make DCP settings.
Assign the parameters of the MTX3 to the switches and
knobs of the connected DCP units. Here you can also spec-
ify the brightness of the DCP's LEDs. For details on how to
make DCP settings, refer to "MTX Editor User's Manual."
9. As necessary, make settings for devices
other than the MTX3.
For details, refer to "MTX Setup Manual."
10. Specify and store a preset.
You can use presets to change the volume of zones and the
audio source to play (e.g., SD memory card or CD player)
in a single action. To prevent problems such as a sudden
increase in volume when the MTX3 is operated, we recom-
mend that you store the preset with the output level lowered
∞
to "-infinity ( )." For details on presets and how to recall
them, refer to "Recalling (switching) presets" on page 17,
and "MTX Editor User's Manual."
11. Save your settings and close MTX Editor.
A project file with the extension ".mtx" will be created.

On-site work (Installation and wiring)

Install and connect the system while referring to the schematic
diagram you printed out.
1. Install the MTX3, and make the analog audio
connections.
2. Make digital connections between the MTX3
and any XMV/EXi8/EXo8.
Make a ring connection with the devices equipped with a
[YDIF] connector.
3. Connect the MTX3 to an analog input amp.
4. Set the UNIT ID of the MTX3 and the XMV/
EXi8/EXo8.
Set the UNIT ID for every MTX3 and XMV/EXi8/EXo8
device you connected in the above steps. The UNIT ID is
specified by the combination of the [UNIT ID] rotary switch
and DIP switches located on each device's rear panel. Set
each device to a different UNIT ID so that no conflict occurs.
5. Make connections between the MTX3 and the
DCP units.
Daisy-chain the DCP units. Set the panel ID and termination
settings of the DCP units. For details, refer to the DCP
owner's manual.
Quick Guide
15
MTX3 Owner's Manual