Advertisement
Before attempting to repair or upgrade a recorder, it is advisable to clear a sufficient work space so components such as
the front panel can be rested on the work surface without getting scratched or damaged.
Panel Mounting
Before a new processor board can be fitted the recorder must be removed from the panel. Loosen the mounting clamp
screws, slide the clamp towards the rear of the recorder and remove the clamps and the recorder.
Removing the Case and Rear Panel
To fit a new Processor board the case and back panel must be removed. The case and back panel can be removed as
a single assembly. Remove the 2 screws on each side of the case as shown in the figures below.
Fig1 QX M3 x 6mm
Fig 2 SX M4 x 8mm
Slide the case and rear panel assembly off the recorder.
43-TV-33-58 iss.1 GLO June 06 UK
Fig 1
Remove 2 screws
from each side of the
case
Fig 2
2
Advertisement
