Instructions For Checking The Function Of The System / Quick Start - piezosystem jena ENT Instruction Manual

The recommended environmental conditions:

indoor only

altitude up to 2000 m

temperature: 20...22 °C

relative humidity: 5 ... 80% (non-condensing)

6. instructions for checking the function of the system / quick start

When you open the package, please check to make sure all the necessary parts
are complete (see packing list) and nothing is damaged.
Check the electronics and the actuator for any visible damage:

The top and bottom plate of the actuator (if it does not have another shape)
should be parallel each to each other, without scratches.

If there is any damage to the system please contact our local representative
immediately!

If the packaging material is damaged please confirm this with the shipping
company.
Before you switch on the system, please check:

the power switch should be in the off position

the main voltage supplied in your country is the same as installed for the
system. (Check the voltage label on the backside of the electronics!)

all potentiometers should be in maximum counter clockwise position

the open/closed loop switch (if built in) is in the "closed loop" OFF position

EDA switch (if built in) is in the position 1 (left)

Connect the piezo-element. Connect the power cable.
Be sure the cables are connected properly to the electronics. If you use more
than one actuator and / or multi channel electronics, match the serial number of
the actuator to a corresponding label at the electronic module.

Switch the system on (power = on). The red LED indicates the power supply
is working. After a short delay time the amplifier modules are ready (green
LED).

open loop configuration: the display shows the output voltage

closed loop configuration: the display shows the minimum position of the
actuator (Pos. 1) in open loop operation (see sketch 1)
Geschäftsführer: Dr. Bernt Götz • Telefon 03641/66880 • Fax 03641/668866 • www.piezosystem.com
37