FUEL & ENGINE
• Camshaft/rocker arm 2-17
• Exhaust pipe/muffler 3-15
• Intake pipe mounting bolts/insulator 2-8
• Spark plug 4-22
• EOT sensor 4-19
• O
sensor 4-20
2
•
Remove the cylinder head bolts.
•
Loosen the cylinder head nuts in a crisscross pattern in several steps.
•
Remove the left side stud bolts.
•
Loosen the right side stud bolts, then pull and remove the stud bolts together with the cylinder head.
•
Install the cam chain guide while aligning its pins with the grooves on the cylinder and its end with the
groove on the left crankcase.
•
After tightening the cylinder head nuts, check that the length from the cylinder stud bolt head to the cylinder
head nut upper surface is within specification.
2-18
7.4 – 12 mm
9.0 N·m
30 N·m