Table of Contents
Advertisement
Change speaker settings
Ideally, the distance between listening position
and all the speakers should be the same. If not,
change the speaker settings based on their
distance from the listening position to obtain
the best possible surround sound.
Audio Setup
Speakers Volume
Speakers Delay
HDMI Audio
CD Upsampling
Audio Sync
1
Press DISC .
2
SETUP .
Press
3
to select [Audio Setup] in the
Press
menu, then press .
•
If the speaker setup option is not
accessible, press
try the above steps again.
To set the speakers level
1
Select [Speakers Volume] in the menu,
then press .
Speakers Level Setup
Front Left
Front Right
Center
Subwoofer
Rear Left
Rear Right
twice before you
0dB
0dB
0dB
0dB
0dB
0dB
2
Press
to change the volume level,
then press OK .
The test tone is emitted from the
»
speaker.
•
Repeat the above setting for other
speakers until all the speakers'
output level sounds equally balance.
•
To exit the menu, press
To set the output delay time (centre and rear
speakers only)
1
Select [Speakers Delay] in the menu,
then press .
Speakers Distance Setup
Center
Rear Left
Rear Right
2
Press
to set the delay time, then press
OK .
•
Repeat the above setting for other
speakers until the sound output from
different speakers reach the listening
position at the same time.
•
To exit the menu, press
Tip
•
Set a longer delay time if the centre speaker or rear
speaker is closer to the listening position than the
front speaker.
•
Allow 1ms setting for every 1 foot distance between
the speaker and the listening position.
SETUP .
0MS
0MS
0MS
SETUP .
EN
19
Advertisement
Table of Contents
