Wireless Connection - IDS RIS Hi-Mod Installation Manual And User's Manual

IDS Ingegneria Dei Sistemi S.p.A.
RIS Hi-Mod / DUALF-400-900 - Installation Guide
and User Manual

2.3 Wireless connection

Here below you can see the requirements and steps to connect by wireless DAD to
PC:
1) System requirement: wireless network board of PC must support
network protocol type 802.11g.
2) Disconnect Lan cable from DAD and from PC.
3) Connect the wireless plug on LAN port of the DAD (Fig. 2.1 e Fig.
2.11).
4) Activate wireless network on PC choosing "ON" with the button on
relative port shown in in Fig. 2.10.
5) Set up wireless board on PC with the following IP address:
192.168.200.195.
6) Disable all boards present within "network connections" window on
PC.
7) Switch off PC and reboot operating system.
8) Enable wireless board.
9) Switch on the DAD.
10) Wait for signal on PC of activating connection RIS K2.
11) Launch K2_FW software icon setting up as configuration file
"TRMF_HiMod_1A_WiFi (see Fig. 2.12).
Fig. 2.10 – Wireless port to be activated on CF-19
40
N. doc.: MN/2009/056 - Rev. 1.1
/
44
WIRELESS
ON