Table of Contents
Advertisement
IDS Ingegneria Dei Sistemi S.p.A.
RIS Hi-Mod / DUALF-400-900 - Installation Guide
and User Manual
Finally put the DAD Control unit inside the box in the middle of the rudder (Fig.
1.9) and the battery in one of the two small black bags
Fig. 1.9 – Insertion of the DAD Control Unit and battery
1.1.2 Wiring
Once the DAD unit is in place you have to connect it with the magnetic encoder,
the antenna, the battery and your laptop.
The magnetic encoder cable is located on one of the wheel frames. Let it pass
through the black strip on the rudder until you reach the first ferrite then link the
connector with the Wheel port of the DAD unit (Fig. 1.10).
Fig. 1.10 – Magnetic encoder cable
/
20
44
N. doc.: MN/2009/056 - Rev. 1.1
.
Advertisement
Table of Contents
