Pieces Counting Function [Counting Mode]; Underfloor Weighing; Density Determination (Hydrostatic Weighing) - G&G JJ-BC Series Operating Instruction

9.6 Pieces counting function [counting mode]

Before the balance can count parts, it must know the average part weight (i.e. reference). Proceed by
putting on a certain number of the parts to be counted. The balance determines the total weight and
divides it by the number of parts, the so-called reference quantity (1, 10, 20, 50, or 100). Counting is then
carried out on the basis of the calculated average piece weight.
As a rule: The higher the reference quantity the higher the counting exactness.
Follow these steps:
a) Place as many pieces to add-up as required by the reference quantity. Press the "COUNT" key, display
"1" that means into the counting mode, Press the [UNIT] button to enter the setting menu. The display
now shows the number "1" and the unit "Pcs". Using the [UNIT] button select the reference quantity
(1, 10, 20, 50, or 100).
b) After successful reference determination the current quantity is displayed and the unit "Pcs".
c) Remove reference weight. The balance is now in parts counting mode counting all units on the
weighing plate.

9.7 Underfloor weighing

Objects unsuitable for placing on the weighing scale due to size or shape may be weighed with the help of
the underfloor weighing device.
Proceed as follows:
 Switch off the balance
 Open the Sealing cap at the balance bottom.
 Suspend hook for underfloor weighing carefully and completely.
 Place weighing balance over an opening.
 Attach load to hook and carry out weighing procedure.
 Always ensure that all suspended objects are stable enough to hold the desired
 Never suspend loads that exceed the stated maximum load (max) (danger of
 Always ensure that there are no persons, animals or objects that might be
 After completing the underfloor weighing the opening on the bottom of the

10 Density determination (Hydrostatic weighing)

According to the Archimedes' principle, any object, wholly or partially immersed in a fluid, is buoyed up by
a force equal to the weight of the fluid displaced by the object. In other words, an immersed object is
buoyed up by a force equal to the weight of the fluid it actually displaces.
For the density determination of solid material, the solid is weighed first in air and then in the measuring
liquid. Because of the density of the water is 1.0 g/cm ³, can determine the volume of the displaced water
and also the volume of object. From the weight difference results the buoyancy calculates the density.
 The density is determined with help of the underfloor weighing device.
 Hydrostatic density determinations succeed only with the objects, which have a
higher density than water (1 g/cm
goods to be weighed safely (danger of breaking).
breaking).
damaged underneath the load.
balance must always be closed (dust protection).
G&G GmbH | Density determination (Hydrostatic weighing)
3
).
12