General Instructions; Nozzle Installation; Faucet Installation - T&S B-1100 Series Installation And Maintenance Instructions Manual

General Instructions

Nozzle Installation

Nozzle Installation
Note: Nozzle should be installed fi rst. See diagram below. Note: Nozzle should be installed fi rst. See diagram below.
1. 1. Shut off water supply and drain lines. Insert no. Shut off water supply and drain lines. Insert no.16
sink. For a rigid nozzle, install no. sink. For a rigid nozzle, install no.13
19 fi rmly with a wrench.
2. 2. Tighten no. Tighten no.19 fi rmly with a wrench.

Faucet Installation

Faucet Installation
3. 3. Drill (2) two holes into sink or countertop where you are installing no. Drill (2) two holes into sink or countertop where you are installing no.1. .
Note: Inlet spacing: 3-1/2", 4" or 8" center to center. Note: Inlet spacing: 3-1/2", 4" or 8" center to center.
4. 4. Apply Plumber's Putty to the bottom face of no. Apply Plumber's Putty to the bottom face of no.5. . Position no.
drilled countertop. drilled countertop.
5. 5. Install no. Install no.2 and no. and no.3 on each no.
to be used. to be used.
6. 6. Connect water supply to no. Connect water supply to no.1 shanks or no.
13 into no. into no.1 outlet.
19 19
13 13
on each no.1 shank and shank and tighten. Install no.
shanks or no.4 (if (if applicable) and check for leaks.
1, 5 1, 5
2
3
4
(optional) (optional
16 into no.
into no.1 and rotate to front of
outlet.
16 16
NOTE: See repair kit NOTE: See repair kit
011643-45 for replacement 011643-45 for replacement
of no. of no.22
1
Position no.1 into the
tighten. Install no.4 if they are
applicable) and check for leaks.
countertop countertop
4
and rotate to front of
22 and no. 23.
and no.23
21 21
23 23
22 22
into the
if they are