C) Batteries - Whelen Engineering Company WPS-2900 Series Installation Manual

c) Batteries

1. Make sure that the system battery switch is in the OFF position.
2. Install the batteries included with your system and connect them as shown in the
illustration representing your cabinet type. MAKE SURE TO OBSERVE THE
POLARITY OF THE TERMINALS BEFORE MAKING ANY CONNECTIONS.
NOTE: For battery wiring, DC wiring conventions are used (BLACK is ground (-)).
For Type II Cabinets (see "Fig. 15: Battery Connections (Type II Cabinet)" on page 31)
Type III Cabinets (see "Fig. 16: Battery Connections (Type III Cabinet)" on page 32)
3. Rotate the system battery switch to the ON position.
4. Plug the battery charger into the AC outlet.
5. Verify system operation as outlined in the system maintenance check list.
Page 30