Invacare Matrx SMH User Manual page 3

TRD0247- Split Mounting Hardware Installation, Rev 4.0 (Europe)_Layout 1 20/12/2011 4:06 PM Page 3
- 3 -
2.0 - Hardware Kit Contents
The Split Mounting Hardware has been uniquely designed to allow for mounting
of our MaTRx Series wheelchair backs when a rigidizer bar is installed between the
wheelchair's back canes. The easy to use split mounting hardware still maintains a
high degree of adjustability, while effectively eliminating any interference issues
experienced with our standard mounting hardware.
Note: the Split Mounting Hardware is not recommended for use with MaTRx-PB Heavy Duty backs)
Split Mounting Hardware Overview Drawing
(Right Side)
Figure 1.0
(Note: Right Ass'y Shown)