Getting Started - GRE CSPA Instruction Manual

the cleaner.

GETTING STARTED

Set Up for Battery Charging
(1) Open the cover on the charging hole, take it out.
Note: There is rope connecting the cover and the cleaner body, and please do
not pull it out strongly in case it will cause the rope broken.
(2) Put the charge onto the suitable socket, and the green indicator will be
lighting.
(3) Put the charger onto the charging hole, and insert.
(4) The red indicator will be lighting and the green indicator is off.
(5) It takes about 3 hours to have the battery full of electricity.
(6)Pull off the charger from the socket, and take the charger from the charging
hole on the electric cleaner.
(7)Screw the cover clockwise tightly to the buckle in order to guarantee it will
not have the leakage.
Note: When screw the cover, you should put your hand inside the body in
order the rope will be stuck into the screw on the body
(8) Now you can begin to use your electric cleaner.
Note: when the charging is over, be sure that the charging screw rotating to
the position the picture B shows ( in order to guarantee no leakage), and then
begin to use the electric cleaner.
WARNING!
Charging must be done in indoors, in a well ventilated area away from the
sunlight, children, heat and ignition sources.
Never use the charger if any damage is found.
Use the original the charger provided only.
Make sure cleaner and the charger are clean and dry before set up.
We can also use the coin to screw
the charging cover as the picture
shows.
4