Declaration Of Conformity (Ce) - stayer GS-0 Operating Instructions Manual

8. INSPECTION
Before each use, mandatorily inspect the equipment. Do
not use the equipment if it does not comply with any of the
following circumstances. Any component not valid should
be replaced immediately.
The harness to the head is clean, complete and adjusts
perfectly to the head.
The helmet is clean, complete and does not present any
type of crack.
The filters should be complete with no embedded
projection chips or cracks, including the protection lenses.
The filter must cover completely is slot in a way the no
type of light passes through.
The photo sensors must be visible under any circumstance
and not covered by any particles.
The filter should not be used if it has exceeded its
expiration date. Verify that 2 years have not passed
from the traceability code. Check the first four characters
(starting from the left) in the code marked on interior part
of the automatic darkening filter. First two are the year and
second ones are the week.
Make sure that the automatic filter doesn't fails and
darkens immediately after the welding arc appears. If not,
reject it from using and contact your dealer immediately.
Don't test directly with a welding arc for security.
Recommended procedure is:
1. To use a cigarette lighter for testing automatic filter.
Only with the sparks the filter must immediately darken
in any position of the sensitivity control 15.
2. To face the welding mask against the direct sun light
and verify that filter darkens. Increase first sensitivity
control 15 between medium and high.
Always test before use!
Sensors of the automatic darkening filter should be kept
clean and unobscured.
ENGLISH
22
9. DECLARATION OF CONFORMITY CE
The undersigned:
STAYER IBÉRICA, S.A.
Address:
Sierra de Cazorla 7
Área empresarial Andalucía Sector 1
28320 Pinto (Madrid) SPAIN
Tel: +34 91 691 86 30 / Fax: +34 91 691 86 31
CERTIFY THAT
Individual protection equipment:
Type: Welding Mask with automatic filter.
Is in compliance with the provisions of annex II of Directive
89/686/ECC (Edition 1989-12) and standards:
DIN EN 166:2002-04 for protective oculars.
DIN EN 175:1997-08 for helmet sell.
DIN EN 379:2009-07 for automatic welding filter.
Notified body name and address:
DIN CERTCO Gesellschaft fuer onformitaetsbewertung
mbH Alboinstrasse 56 - 12103 Berlin.
Notified body number 0196.
Signed: Ramiro de la Fuente Muela
Manager Director
22
January, 2017