Equipment must not be altered in any way.
Repairs must be performed only by the
manufacturer, or persons or entities authorized
in writing by the manufacturer.
Any product exhibiting deformities, unusual
wear, or deterioration must be immediately
Any equipment subject to a fall must be
removed from service.
The authorized person/user shall have
a rescue plan and the means at hand to
implement it when using this equipment.
Never use fall protection equipment for
purposes other than those for which it was
Equipment must not be exposed to
environmental hazards and chemicals which
may produce a harmful effect.
3.0 Tripod Installation
7 ft. (2.1m) high-strength aluminum tripod
51X/9FT 9 ft. (2.7m) high-strength aluminum tripod
Us er In stru ctio ns - Engli sh
Do not allow equipment to come in contact
with anything that will damage it including,
but not limited to, sharp, abrasive, rough
or high-temperature surfaces, welding,
heat sources, electrical hazards, or moving
Do not expose the equipment to any hazard
which it is not designed to withstand. Consult
the manufacturer in cases of doubt.
Always check for obstructions below the work
area to make sure potential fall path is clear.
Allow adequate fall clearance below the work
Never remove product labels, which include
important warnings and information for the
Retracted / Extended
45.5 in. (1155.7mm) /
81.5 in. (2070.1mm)
67.5 in. (1714.5mm) /
104.5 in. (2654.3mm)