Mercedes-Benz Atego Manual page 78

Transmission
Major teach-in process
The major teach-in process is necessary when
• The GS control unit has been replaced
• The engine has been replaced
• Fault code a 2 1011
• Fault code a 2 8093
i
If fault code a 2 1011
seconds and then turn it back to the drive position.
Press and hold down neutral button and function button.
Turn vehicle key in steering lock to drive position.
Start the engine within 10 seconds when the transmission neutral position
Release neutral button and function button.
The teach-in process is complete.
!
If the fault displays do not disappear after the teach-in process, have the fault rectified at a qualified
specialist workshop possessing the required expertise and tools in order to perform the necessary work.
Mercedes-Benz recommends a Mercedes-Benz service center for this work.
76
Guidelines for Breakdown Services (Subject to technical modifications)
i
is displayed
is displayed
was displayed, turn the vehicle key in the steering lock all the way back, wait about 5
N flashes in the display.