1. Important Safety Instructions SAVE THESE INSTRUCTIONS This manual contains instructions and warnings that must be followed during the installation and operation of the product described in this manual. Failure to comply may invalidate the warranty and cause property damage or personal injury.
3. Feature Identification Front View Rear View *CST16AC 16-device slot model shown. CST20AC contains 20 device slots. **Both the CST16AC and CST20AC models use a 20-outlet power distribution unit. Locking Front Door AC Power Distribution Unit Storage Shelves 10 ft. Power Cord with 5-15P Plug...
4. Setup Caution! Read all instructions and warnings before installation! Warning: The charging station tower unit is heavy. Use caution when handling the charging station tower unit. Do not attempt to unpack, move or install it unassisted. Use extreme caution when handling the charging station tower unit.
Page 5
4. Setup Determine the charging station tower’s permanent mounting location along the wall. Ensure the 10-ft. power cord and input plug are able to connect to a nearby power outlet. Use the included fold-out template to mark the locations where the charging station tower’s wall-mount brackets will be used to secure the charging station tower to the wall WALL...
Insert the power adapter shelf tabs into the slots located on the tower’s rear panel. Repeat as needed. *CST16AC 16-device slot model shown. CST20AC contains 20 power adapter shelves and slots. Installing the Device’s AC Power Supply Place the device’s AC power supply on the power adapter shelf and secure with the thumbscrew Then, plug the device’s AC power supply into the power distribution unit...
5. Installation 5.1 Power Requirements The charging station must be plugged into an AC outlet with a dedicated circuit. An AC outlet with a 20-amp (NEMA 5-20R) AC circuit is recommended for powering the charging station. The AC outlet used to power the charging station should not be shared.
5. Installation To secure the charging station tower to the wall, tighten the mounting hardware to the charging station tower’s wall-mount brackets 5.3 Powering the Charging Station Tower Once all AC power supplies have been connected to the charging tower’s distribution unit (see section 4.3 Connecting Power Adapters) and the charging station has been secured to a wall surface (see section 5.2 Mounting the Charging Station Tower), connect the charging station...
The top door allows for easy access to any unused device slots near the top of the unit for easier future expansion of installed devices. 6. Specifications Model CST16AC CST20AC Dimensions (H x W x D) 44.5 x 13 x 21 in. / 1130 x 330 x 533 mm 52.5 x 13 x 21 / 1334 330 x 533 mm...
7. Optional Caster Kit For applications requiring extra mobility, an optional caster kit (Model: CSTCASTERKIT16 or CSTCASTERKIT20) contains four casters, a base, handle set and locking rear door. For further installation instructions, refer to the manual included with the caster kit. 8.
9. Warranty and Product Registration Seller warrants this product, if used in accordance with all applicable instructions, to be free from original defects in material and workmanship for a period of 2 years from the date of initial purchase. If the product should prove defective in material or workmanship within that period, Seller will repair or replace the product, at its sole discretion.
Page 12
1111 W. 35th Street, Chicago, IL 60609 USA • www.tripplite.com/support 19-05-298 93-39A1_RevA...
Need help?
Do you have a question about the CST16AC and is the answer not in the manual?
Questions and answers