Table of Contents
Advertisement
EN 12
4.
VES15.1HE LA
4.2
Service Positions
For easy servicing of a TV set, the set should be put face down
on a soft flat surface, foam buffers or other specific workshop
tools. Ensure that a stable situation is created to perform
measurements and alignments. When using foam bars take
care that these always support the cabinet and never only the
display. Caution: Failure to follow these guidelines can
seriously damage the display!
Ensure that ESD safe measures are taken.
4.3
Assembly/Panel Removal
Carefully lay the set on a flat, cushioned surface with the
display side facing down and the stand hanging over the edge.
4.3.1
Rear Cover (19", 24")
Refer to
Figure 4-7
and
Warning: Disconnect the mains power cord before removing
the rear cover.
1. Press on the round button on the upper side of the stand
and remove it by pulling out gently.
2. Unscrew all the screws [1] and [2].
3. At the indicated areas [Blue points] the cover is secured by
clips. Be careful when releasing those.
4. Lift the rear cover from the TV. Make sure that wires are not
damaged while lifting the rear cover from the set.
4.3.2
Rear Cover (28", 32", 40", 48")
Refer to
Figure
4-9,
Figure
for details.
Warning: Disconnect the mains power cord before removing
the rear cover.
1. Remove the screws [1] that fixate the stand and remove
the stand.
2. Unscrew all the remaining screws [2] and [3].
2015-Jan-20
Mechanical Instructions
Figure 4-6 Cable dressing (48" 2000 series)
Figure 4-8
for details.
4-10,
Figure 4-11
and
Figure 4-12
Unscrew all the remaining screws [2]. (32")
Unscrew all the remaining screws [2], [3] and [4]. (48")
3. At the indicated areas [Blue points] the cover is secured by
clips. Be careful when releasing those.
4. Lift the rear cover from the TV. Make sure that wires are not
damaged while lifting the rear cover from the set.
back to
div. table
19830_108_152001.eps
152001
Advertisement
Table of Contents
