Table of Contents
Advertisement
Installing your LCD TV
Remote Control
6
Positioning the television set
Place your TV on a solid stable surface.
To avoid danger do not expose the TV
to water, or heat source (e.g. lamp,
candle, radiator). Do not obstruct the
ventilation grid at the rear.
Connecting the aerials
• Use the aerial connection lead and
connect the : socket situated at
the bottom of the TV to your aerial
socket.
• Connect the power lead to the
television and the mains plug into the
wall socket (220-240 V 50/60 Hz).
For connecting other appliances see page
Quick Use Guide.
Switching on
To switch on the set, press the
POWER button. A green indicator
comes on and the screen lights up. Go
straight to the Quick Installation chapter.
If the TV remains in standby mode
(red indicator), press the P –/+ on the
remote control.
The indicator will flash when you use the
remote control.
Pull out the plastic insulation sheet from the
battery, this will activate the remote control.
The battery supplied with the appliance does
not contain mercury or nickel cadmium so
as to protect the environment. Please do
not discard your used batteries, but use the
recycling methods available (consult your
distributor).
Advertisement
Table of Contents
