Adjustment Of The Bender - Hohner UNIVERSAL 52/8 S Operating Instructions, Spare Parts List, Special Staples, Options

Operation

3.8 Adjustment of the bender

- Fig. 16, Fig. 17 -
In order to achieve perfect stitching the stitching head must be set to the stroke height of the
stitching unit (basic settings factory-set). This setting only needs to be corrected if the latch in
the bender does not unlatch in the topmost position, i.e. if the latch does not protrude from the
sides of the bender by approx. 2.5 mm.
To readjust:
- Move the stitching unit in the lowest position and remove former (see 4.2.1).
- Undo locknut and unscrew check screw .
- Tighten locknut after adjustment.
- Run unit and check whether the latch is unlatched.
Repeat procedure – if necessary – until perfect functioning is ensured.
- Refit former (see 4.2.1).
Hohner Maschinenbau GmbH HK 52/8 S 35