Setting The Leg Length Of The Stitch; Manual Adjustment Of The Leg Length (Without Central Adjustment) - Hohner UNIVERSAL 52/8 S Operating Instructions, Spare Parts List, Special Staples, Options

3.6.3 Setting the leg length of the stitch

- Fig. 12a, Fig. 12b -
After having set the wire length the leg length of the staple must be adjusted. Set the stitching unit
to 2-sheet stitching.
- Undo the Torx screw
- Shift the adjustment rods
equal length.
- Tighten the Torx screw
Test the leg length by a test stitch. Repeat procedure if a correction is necessary.
Normal stitch
set higher value
Loop stitch
set higher value

3.6.4 Manual adjustment of the leg length (without central adjustment)

- Fig. 12a, Fig. 12b -
After having set the wire length the leg length of the staple must be adjusted. Both the staple legs
must be of equal length. The leg length of the staple depends on the stitch thickness of the
material to be stitched. Adjust the knives box
adapt the leg length to the material to be stitched. The notch at the scale pin
value of the stitch thickness in mm for normal staples.
The end of the scale pin
clamps (-L6-).
Hohner Maschinenbau GmbH
.
by adjusting the adjustment lever
.
set lower value
set lower value
marks the set value of the stitch thickness in mm for loop-stitching
HK 52/8 S
. Both the staple legs must be of
by adjusting the adjustment lever
Operation
in order to
marks the set
31