Hubbell GAI-TRONICS HUBBCOM GRC600 Quick Installation Manual

HUBBCOM™ Remote GRC600 Station

General Information

This guide covers the installation of the HUBBCOM Model
GRC600 Remote Station. The Model GRC600 Remote
Station is designed for use as an access control device and/or
a remote audio/video monitoring station. It can function in a
standalone configuration or as part of a HUBBCOM system.
See the GAI-Tronics website at
for system specifications, warranty information, and the
GUDA (GAI-Tronics Universal Device Application).

Important Safety Instructions

•
Read, follow, and retain instructions—All safety and
operating instructions should be read and followed
before operating the unit. Retain instructions for future
reference.
•
Heed warnings—Adhere to all warnings on the unit and
in the operating instructions.
•
Attachments—Attachments not recommended by the
product manufacturer should not be used, as they may
cause hazards.
•
Servicing—Do not attempt to service this unit by
yourself. Opening or removing covers may expose you
to dangerous voltage or other hazards. Refer all
servicing to qualified service personnel.
•
HUBBCOM Smart Controllers are designed for indoor
use only.
ATTENTION
These enclosures must be installed by trained, qualified and competent personnel. Installation must comply with state and
national regulations, as well as safety practices for this type of equipment.
WARNING
—Use only 12 or 24 V dc power supplies that conform to UL/CSA/CE Class II, Double Insulated
•
Onderhoud—Probeer dit apparaat niet zelf te repareren. Het openen of verwijderen van afdekkingen kan u blootstellen
aan gevaarlijke spanning of andere gevaren. Laat alle onderhoud over aan bevoegd onderhoudspersoneel.
•
HUBBCOM Smart Controllers zijn alleen bedoeld voor gebruik binnenshuis.
GAI-TRONICS 3030 KUTZTOWN RD. READING, PA 19605 USA
V
G A I - T R O N I C S
A H U B B E L L C O M P A N Y
Quick Installation Guide
https://www.gai-tronics.com
—Install equipment without modification and according to all applicable local, national, and
international electrical codes. North America - Consult the National Electrical Code (NFPA
70), Canadian Standards Association (CSA 22.1), and local codes for specific requirements
regarding your installation. Class 2 circuit wiring must be performed in accordance with the
NEC.
supplies with over voltage and short circuit protection. Use only a dc source with a 50-watt
maximum output or fuse the supply with a 2-amp fuse. EMI standards to Class B.
610-777-1374  800-492-1212  Fax: 610-796-5954
. - .
ISIT WWW GAI TRONICS COM FOR PRODUCT LITERATURE AND MANUALS
®
Figure 1. HUBBCOM Remote Station
Pub. 42004-538AQG