Remote Control Unit - C.E.C. DA5 Owner's Manual

Front Panel Functions - continued -
or any digital signal is not detected properly the
indicator won't light up.
④ Sampling Frequency / Volume indicator
A sampling frequency of a selected input signal
being played is displayed. When an input is selected
without any connection or without any input signal,
or when any input signal can not be detected
properly, three bars "- - -" will be displayed instead of
sampling frequency.
Pressing the D.VOL-UP/DN buttons on the remote
control unit to adjust the volume (analog outputs
level) will change to indicate the volume level. Refer
to "Digital Volume" on page 9 for details. 5 seconds
later the display will return to show a sampling
frequency.

Remote Control unit

Buttons function
to buttons work for
DA5 and the others are
compatible with the other
C E C p r o d u c t s l i k e C D
Transport TL5, CD Player
CD5, D/A Converter DA3N
and so on. Here refers to
DA5 function only.
DIMMER button
Press to change the
display brightness in
different 3 levels. Refer
to "DIMMER" on page 11
for details.
D.FILTER button
Press to select a digital
filter type FLAT or PULSE. Refer to "Digital Filter" on
page 11 for details.
Direct input selector buttons (TOS, AES/EBU,
COAX, USB)
Press TOS, AES/EBU, COAX or USB to select an
input directly.
INPUT button
Press to change the input in
an order described right.
8
Remote Control unit - continued -
Precaution on handling the remote control
unit
□ When operating the remote control, point it towards the
□ Make sure nothing is blocking the front panel where
□ Avoid exposing the remote sensor on the front panel to
□ The remote control unit may malfunction when its
Battery Installation
battery compartment. Insert
two AAA batteries into
the compartment. Make
sure that the batteries
are inserted with their positive (+) and negative (-) poles
positioned correctly, and put the cover back on.
Battery Replacement Period
used to operate DA5 seems to be decreasing, replace
both batteries with new ones.
Precaution on handling batteries
□ Never use different types of batteries together. Both
□ If you will not be using the remote control unit for an
□ If the batteries leak, use a cloth to wipe away the
□ Do not heat or disassemble batteries, and never
USB COAX
AES TOS
D.VOL-UP/DN button
Press D.VOL-UP button to increase or D.VOL-DN
button to decrease the digital volume. Pressing and
holding the button allows fast changes. Refer to "Digial
Volume" on page 9 for details.
remote sensor on the front panel.
the remote sensor is lolocated.
direct sunlight or other light sources, as such exposure
can cause malfunction.
batteries are running low. Change the batteries to new
ones of the same type if this seems to be the case.
Remove the cover of the
If the distance at which the remote control unit can be
rechargeable and non-rechargeable batteries can be
used, but the two should not be used together.
extended period of time (more than a month), remove
the batteries to prevent leakage.
liquid inside the battery compartment and replace the
batteries with new ones.
dispose of old batteries by throwing them in a fire.
Dispose of batteries following laws in the local area.