Accessories On Select Models - DJG Deluxe High Back 65 Instructions Manual

7.
Thread Harness Strap
Over Metal Bar
From the back, pull harness
straps through the back.
Harness straps
go
BETWEEN
plastic headrest adjustment
handle.
8.
Attach Harness Straps to
Splitter Plate
From the back of the child
restraint, fit the harness strap
loops onto the splitter plate.
Make sure sewn ends of the
harness strap loops face
towards you. DO NOT twist
harness straps or harness
adjustment strap and make sure the harness straps are
COMPLETELY ON the splitter plate.
Failure to place harness straps over the metal
bar, between metal bar and plastic headrest
adjustment handle, can result in serious injury
or death to your child.
You must install the harness system properly.
Failure to follow these warnings can result in
serious injury or death.
29
4358-6862A Deluxe High Back 65 ENG.indd 31-32 4358-6862A Deluxe High Back 65 ENG.indd 31-32
MUST
OVER the metal bar,
the metal bar and
C-8 Accessories on Select Models
Cup Holder
Pull pad off corner at child's
left side. Hook bottom
of cup holder on bottom
edge of child restraint and
rotate cup holder up.
Snap top of cup holder on
top edge of child restraint.
Make certain cup holder is
flush on the top and sides
of child restraint.
Replace pad.
Harness Covers
The harness covers help
to provide comfort to the
child's neck. For harness
covers to fit correctly you
may have to push the ends
of the covers through the
upper harness slots.
To remove, unhook the
harness straps from
splitter plate, pull harness
straps out of the upper
harness slots and remove
harness covers.
Rethread harness straps
and re-hook the harness
strap loops onto the splitter
plate (see section C-7).
30
6/15/18 7:49 PM 6/15/18 7:49 PM