Installing Harness System - DJG Deluxe High Back 65 Instructions Manual

C-7 Installing Harness System
1.
Install Buckle Strap
Choose one of the three slots
that is closest to child.
1
From the front of child restraint,
2
push buckle strap's metal
3
retainer and buckle cover
through pad and shell. Make sure that buckle is facing out.
2.
From bottom of child
restraint, pull buckle strap's
metal retainer completely
through pad and shell.
3. Check Buckle
Pull up on buckle strap to
make sure it is secured.
The buckle must not pull
out.
Failure to place buckle strap's metal retainer
completely through pad and shell can result
in serious injury or death to the child.
4.
Thread Harness Strap
(1) With sewn end of the
harness strap loop facing
the buckle,
1
strap down through lower
harness guide on left side of
shell.
2
(2)
and up through lower harness
guide on right side of shell.
NOTE:
remove the harness guides. See section C-6, step 3.
27
4358-6862A Deluxe High Back 65 ENG.indd 29-30 4358-6862A Deluxe High Back 65 ENG.indd 29-30
thread the harness
Pull across bottom of shell
For easier assembly,
Failure to place the harness
adjustment strap between shell
and the harness straps as shown
can result in serious injury or
death.
5.
Take both ends of the
harness strap and make
them even in length.
The sewn ends of the
harness strap loops
face each other as shown.
6. (3) Thread left harness
5
strap through the
the left buckle tongue
and the right harness strap
through the
4
right buckle tongue.
(4) Thread the chest clip
3
from
shown.
(5) Push left harness strap
through harness cover and
4
left upper harness slot and
right harness strap through
harness cover and right
upper harness slot at the same height.
DO NOT twist harness straps.
28
MUST
back of
back of the
front to back as
continued on next page.
6/15/18 7:49 PM 6/15/18 7:49 PM