DJG Deluxe High Back 65 Instructions Manual page 23

F-5 Install Forward Facing
With Vehicle Belts
NOTE: Review section D-4 to determine what kind of
vehicle belts you have. Review your vehicle owner's manual
for vehicle seat belt use.
Do not use the UAS along
with the vehicle lap or lap/
shoulder belt. You must
store the UAS when using
the vehicle seat belts.
Check the vehicle belt before each use.
Use only if the belt can be tightened
properly and securely.
Do not use this seat with the kickstand
folded under.
Failure to follow these warnings can result
in serious injury or death.
1. Place Child Restraint in
Vehicle Forward Facing
Flush Against Back Seat
Kickstand
folded out in order to use
this seat.
43
4358-6862A Deluxe High Back 65 ENG.indd 45-46 4358-6862A Deluxe High Back 65 ENG.indd 45-46
With a switchable retractor, pull the shoulder belt all the
way out to switch the retractor into the ALR mode before
tightening.
Buckle vehicle belt.
MUST be
Installation Tip:
Loosely attach
the tether hook
before threading
the vehicle belt.
Consult vehicle
owner's manual
for specific
location.
2.
Thread Vehicle Belt
Thread the vehicle lap or
lap/shoulder belt through
the forward-facing belt path
and out the other side.
With an ALR vehicle belt,
pull the vehicle belt all the
way out before threading
the child restraint.
3.
Tighten Vehicle Belt
Place knee in the child
restraint. Push down firmly
while pulling up on the
vehicle shoulder belt or lap
belt to tighten.
With a switchable retractor,
feed the shoulder belt back
into the retractor while
tightening.
continued on next page.
44
6/15/18 7:49 PM 6/15/18 7:49 PM