Advertisement
Available languages
Available languages
5. Use of an attachment not recommended or sold by Black & Decker may result in a risk
of fire, electric shock, or injury to persons.
6. To reduce risk of damage to electric plug and cord, pull by plug rather than cord when
disconnecting charger.
7. Make sure cord is located so that it will not be stepped on, tripped over, or otherwise
subjected to damage or stress.
8. An extension cord should not be used unless absolutely necessary. Use of improper
extension cord could result in a risk of fire, electric shock or electrocution.
a. Two-wire cords can be used with 2-wire or 3-wire extension cords. Only round
jacketed extension cords should be used, and we recommend that they be listed by
Underwriters Laboratories (U.L.). If the extension is to be used outside, the cord
must be suitable for outdoor use. Any cord marked for outdoor use can also be
used for indoor work. The letters "W" or "WA" on the cord jacket indicate that the
cord is suitable for outdoor use.
b. An extension cord must have adequate wire size (AWG or American Wire Gauge)
for safety, and to prevent loss of power and overheating. The smaller the gauge
number of the wire, the greater the capacity of the cable; that is, 16 gauge has more
capacity than 18 gauge. When using more than one extension to make up the total
length, be sure each extension contains at least the minimum wire size.
CHART FOR MINIMUM WIRE SIZE (AWG) OF EXTENSION CORDS
NAMEPLATE RATING AMPS – 0 – 10.0
Total Extension Cord Length (ft)
0-25
(0-7,6m)
Wire Gauge
18
9. Use only the supplied charger when charging your unit. The use of any other charger
could damage the battery pack or create a hazardous condition.
10. Use only one charger when charging.
11. Do not attempt to open the charger or the unit. There are no customer serviceable
parts inside. Return to any authorized Black & Decker service center.
12. DO NOT incinerate battery packs even if they are severely damaged or completely
worn out.
13. Do not incinerate the batteries. They can explode in a fire. A small leakage of liquid
from the battery cells may occur under extreme usage, charging or temperature
conditions. This does not indicate a failure. However, if the outer seal is broken and this
leakage gets on your skin:
a. Wash quickly with soap and water.
b. Neutralize with a mild acid such as lemon juice or vinegar.
c. If the battery liquid gets in your eyes, flush them with clean water for a minimum of
10 minutes and seek immediate medical attention. MEDICAL NOTE: The liquid is a
25-35% solution of potassium hydroxide.
IMPORTANT CHARGING SAFETY INSTRUCTIONS
CHARGING PROCEDURE
THE BATTERY PACK IS NOT FULLY CHARGED AT THE FACTORY. CHARGE BATTERY
PACK FOR AT LEAST 9 HOURS BEFORE USE.
The charger is designed to use standard household 120 volt 60 Hz power.
1. Plug the charger into any standard 120 Volt 60 Hz electrical outlet (figure 1).
2. Slide the charger onto the battery pack as shown in figure 2 and let the battery pack
charge initially for 9 hours. After the initial charge, under normal usage, your battery
pack should be fully charged in 6 to 9 hours.
2a) During charging the green LED will appear.
2b) When charging is complete the green LED will go off.
3. Unplug charger, and remove the battery pack. Place the battery pack into the tool until it
"clicks" into place.
NOTE: To remove the battery pack, press down on the release button on the back of
the battery pack and slide out (figure 3).
IMPORTANT CHARGING NOTES
1. After normal usage, your battery pack should be fully charged in 6 to 9 hours. If the
battery pack is run-down completely, it may take up to 9 hours to become fully
charged. Your battery pack was sent from the factory in an uncharged condition. Before
attempting to use it, it must be charged for at least 9 hours.
2. DO NOT charge the battery pack in an air temperature below +40°F(+4.5°C), or above
+105°F (+40.5°C). This is important and will prevent serious damage to the battery
pack. Longest life and best performance can be obtained if battery pack is charged
when air temperature is about 75°F (24°C).
3. While charging, the charger may hum and become warm to touch. This is a normal
condition and does not indicate a problem.
4. If the battery pack does not charge properly—(1) Check current at receptacle by plug-
ging in a lamp or other appliance. (2) Check to see if receptacle is connected to a light
switch which turns power off when you turn out the lights. (3) Move charger and battery
pack to a surrounding air temperature of 40°F (+4.5°C) to 105°F (+40.5°C). (4) If the
receptacle and temperature are OK, and you do not get proper charging, take or send
the battery pack and charger to your local Black & Decker service center. See Tools
Electric in yellow pages.
5. The battery pack should be recharged when it fails to produce sufficient power on jobs
which were easily done previously. DO NOT CONTINUE using unit with its battery pack
in a depleted condition.
6. The battery pack will reach optimum performance after being cycled 5 times during
normal usage. There is no need to run the battery pack down completely before
recharging. Normal usage is the best method of discharging and recharging the battery
pack.
STORAGE RECOMMENDATION
1. Store tool:
a.) with the battery pack removed and on the charger.
b.) in a place that is cool and dry away from direct sunlight and excess heat or cold.
c.) out of the reach of children.
2. For prolonged storage such as over the winter, the battery pack should be fully charged
and then removed from the charger. It should be charged again just prior to use.
SWITCH
The switch can be operated by moving the lever from side to side. The "ON" and "OFF"
positions are marked on the housing as shown in Figure 4A & 4B.
CAUTION:
DO NOT POINT UNIT DISCHARGE AT SELF OR
BYSTANDERS.
CAUTION:
Always wear safety glasses. Wear a filter mask if the operation
is dusty. Use of gloves, long pants and substantial footwear is recommended. Keep long
hair and loose clothing away from openings and moving parts. THIS SWEEPER IS FOR
HOUSEHOLD USE ONLY.
NOTE: Ensure the blower is switched off and the battery is removed before attaching or
removing the sweeper tubes.
• TUBE ASSEMBLY: To attach the inner tube to the sweeper, line up the tube with the
sweeper housing as shown in figure 5. Push the tube into the sweeper housing until the
lock button engages the lock hole in the tube. Repeat this process for the outer tube.
• Hold the sweeper with one hand as shown in figure 6 and sweep from side to side with the
nozzle several inches above the ground. Slowly advance keeping the accumulated pile of
debris in front of you.
26-50
51-100
101-150
(7,6-15,2m)
(15,2-30,4m)
(30,4-45,7m)
16
16
14
CLEANING AND STORAGE
CAUTION:
DO NOT POUR OR SPRAY WATER ON THE UNIT.
Use only mild soap and a damp cloth to clean the unit. Never let any liquid get inside the
unit; never immerse any part of the unit into a liquid.
Your sweeper should be stored in a dry place. Do not store the unit on or adjacent to
fertilizers or chemicals. Such storage can cause rapid corrosion of the metal parts.
THE RBRC™ SEAL
The RBRC™ (Rechargeable Battery Recycling Corporation)
Seal on the nickel-cadmium battery (or battery pack) indicates that the costs to
recycle the battery (or battery pack) at the end of its useful life have already
been paid by Black & Decker. In some areas, it is illegal to place spent
nickel-cadmium batteries in the trash or municipal solid waste stream and the
RBRC program provides an environmentally conscious alternative.
RBRC in cooperation with Black & Decker and other battery users, has established
programs in the United States and Canada to facilitate the collection of spent nickel-
cadmium batteries. Help protect our environment and conserve natural resources by
returning the spent nickel-cadmium battery to an authorized Black & Decker service center
or to your local retailer for recycling. You may also contact your local recycling center for
information on where to drop off the spent battery, or call 1-800-544-6986
Problem
Possible Cause
• Unit will not start.
• Battery not installed properly.
• Battery not charged.
• Battery will not charge.
• Battery not inserted into charger.
• Charger not plugged in.
• Surrounding air temperature
too hot or too cold.
For assistance with your product, visit our website www.blackanddecker.com for the
location of the service center nearest you or call the BLACK & DECKER help line at
1-800-544-6986.
IMPORTANT
To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment should
be performed by authorized service centers or other qualified service organizations, always
using identical replacement parts.
SERVICE INFORMATION
All Black & Decker Service Centers are staffed with trained personnel to provide customers
with efficient and reliable power tool service. Whether you need technical advice, repair, or
genuine factory replacement parts, contact the Black & Decker location nearest you. To find
your local service location, refer to the yellow page directory under "Tools—Electric" or call:
1-800-544-6986 or visit www.blackanddecker.com
FULL TWO-YEAR HOME USE WARRANTY
Black & Decker (U.S.) Inc. warrants this product for two years against any defects in material
or workmanship. The defective product will be replaced or repaired at no charge in either of
two ways.
The first, which will result in exchanges only, is to return the product to the retailer from
whom it was purchased (provided that the store is a participating retailer). Returns should be
made within the time period of the retailerʼs policy for exchanges (usually 30 to 90 days after
the sale). Proof of purchase may be required. Please check with the retailer for their specific
return policy regarding returns that are beyond the time set for exchanges.
The second option is to take or send the product (prepaid) to a Black & Decker owned or
authorized Service Center for repair or replacement at our option. Proof of purchase may be
required.Black & Decker owned and authorized Service Centers are listed under
"Tools-Electric" in the yellow pages of the phone directory.
This warranty does not apply to accessories. This warranty gives you specific legal rights
and you may have other rights which vary from state to state or province to province. Should
you have any questions, contact the manager of your nearest Black & Decker Service
Center. This product is not intended for commercial use.
FREE WARNING LABEL REPLACEMENT: If your warning labels become illegible or are
missing, call 1-800-544-6986 for a free replacement.
LATIN AMERICA: This warranty does not apply to products sold in Latin America. For
products sold in Latin America, check country specific warranty information contained in the
packaging, call the local company or see the website for warranty information.
Imported by
Black & Decker (U.S.) Inc.,
701 E. Joppa Rd.
Towson, MD 21286 U.S.A.
MODE D'EMPLOI DU BALAI SANS FIL
Code de date
À LIRE AVANT DE RETOURNER CE PRODUIT
POUR QUELQUE RAISON QUE CE SOIT :
HTTP://WWW.BLACKANDDECKER.COM/INSTANTANSWERS
1-800-544-6986
Troubleshooting
Possible Solution
• Check battery installation.
• Check battery charging
requirements.
• Insert battery into charger
until green LED appears.
• Plug charger into a working
outlet. Refer to "Important
Charging Notes" for more
details.
• Check current at receptacle
by plugging in a lamp or other
appliance.
• Check to see if receptacle is
connected to a light switch
which turns power off when
you turn out the lights.
• Move charger and tool to a
surrounding air temperature
of above 40 degree F(4.5°C)
or below 105 degree F
(+40.5°C).
See 'Tools-
Electric'
– Yellow Pages –
for Service &
Sales
Numéro de catalogue :
NS118, NS118L
Advertisement
