Joovv Max Quick Start Manual

STEP 1
Lay out out all 4 Joovv devices on a scratch-free surface. For
the Joovv Max setup, the Mini devices will go on the bottom
and be labeled #3 and #4.
STEP 2
Set the Quad bracket and connection bars on the Joovv Max
or Quad system, making sure to line up all screw locations, as
shown in Figure A for the Quad, and Figure B for the Max.
For the Joovv Max setup, the Mini devices will not use a
connection bar.
STEP 3
Hand-tighten the screws with the included Allen wrench.
STEP 4
After setting up the mobile stand using separate instructions,
hang your Max or Quad and proceed to the next step.
STEP 5
Connect the power and patch cords, as shown in Figure A
and B.
STEP 6
Set the pairing switches to the appropriate lead and follow
modes, as shown in Figure A and B.
STEP 7
Plug in the power cords to a wall outlet and you're ready to
start Joovvin'!
If you'd prefer instructional setup videos,
please visit: www.joovv.com/setup
Joovv Max & Joovv Quad
Quickstart Guide — Mobile Stand
#1 Lead Mode
#3 Follow Mode
#1 Lead Mode
#3 Follow Mode
For comprehensive instructions, please review the product
manual that was included with your Joovv devices.
#2 Follow Mode
#4 Follow Mode
FIG. A
#2 Follow Mode
#4 Follow Mode
FIG. B