Advertisement
®
the gate opener
Made in Italy
EUROPEAN MARK CERTIFYING CONFORMITY TO
THE ESSENTIAL REQUIREMENTS OF THE
STANDARDS 98/37/EC
AUTOMATIC GATE MANUFACTURERS
Via Mantova, 177/A - 37053 Cerea (Verona) Italy - Tel. +39 0442 330422 r.a. - Fax +39 0442 331054 - e-mail: info@fadini.net - www.fadini.net
IMPORTANT WARNING NOTES
- It is recommended to keep to the instructions here outlined - check the specifications on the motor sticker
with your mains supply.
- Dispose properly of the packaging materials: cardboard, nylon, polystyrene etc. through specialized companies.
- Switch off the mains switch before opening the door.
- Should the assembly motor/hydraulic unit be removed, do not cut the electric cables. These must be properly
removed from the terminal board in the junction box.
- All the system must be earthed by means of the yellow/green cable. The specific earth symbol refers for
identification.
- It is recommended to read the regulations, suggestions and remarks contained in the booklet "warnings".
- MECCANICA FADINI recommends the control panel ELPRO 88 exp for a good installation in conformity to the
existing regulations.
- The control panel "ELPRO 88 exp" incorporates all the functions required to operate the road barrier "barri 88".
- Among its features there is the possibility to stop and hold the beam in the required position by pulsing again
the remote control (step by step).
INSPECTIONS AND MAINTENANCE
In order to ensure optimal system performance over time and so as to comply with current safety
standards, it is necessary to follow the correct maintenance and monitoring procedures for the
entire automation, electronic devices and wiring:
- Oil-hydraulic automation: maintenance inspection around every 6 months
- Electronic devices and safety systems: maintenance inspection monthly.
WARNINGS
- Perform a Risk Analysis before every installation and resolve risks through the use of safety devices
in compliance with EN 12445 and EN 12453 safety standards
- Follow the instructions provided
- Check that the information on the electric motor plate conforms to the distributíon network
- Dispose of all cardboard, nylon, polystyrene and other packaging with specialized waste dísposal firms
- lf removing the actuator, do not cut the electric wires, but disconnect them from the terminal box
by loosening the screws inside the junction box
- Disconnect the mains switch before opening the electrical wire junction box cover
- The whole automation should be earthed with the yellow/green wire
- CUSTOMER GUARANTEE CERTIFICATE ON CUSTOMER'S REQUEST
We recommend reading the "warning" regulations, suggestions and observations in this booklet
very carefully.
The "CE" mark certifies that the operator conforms to the essential requirements of the European Directive
art. 10 CEE 73/23, in relation to the manufacturer's declaration for the supplied items, in compliance with
the body of the regulations ISO 9000 = UNI EN 29000. Automation in conformity to EN 12453, EN 12445 safety
standards.
The growth of MECCANICA FADINI has always been based on the development of guaranteed products
thanks to our "TOTAL QUALITY CONTROL" system which ensures constant quality standards, updated
knowledge of the European Standards and compliance with their requirements, in view of an ever
increasing process of improvement.
®
s.n.c.
• DECLARATION OF CONFORMITY
• GENERAL WARNINGS
• EN 12453, EN 12445 STANDARDS
• CEI EN 60204-1 STANDARDS
• WARRANTY CERTIFICATE ON THE CUSTOMER'S REQUEST
Distributor's box
The manufacturers reserve the right to change the products without any previous notice
EN 12453
SAFETY
STANDARDS
EN 12445
Advertisement
