Advertisement
TRAFFIC BARRIER WITH ARTICULATED ARM CUT AT A FACTORY PRE-SET MEASURE
1
2
5
9
8
7
6
10
LEFT-HAND
PIC. 19
TECHNICAL SPECIFICATIONS
ELECTRONIC CONTROL PANEL
Three relays. One for extra safety .......................................24 V - 16 A
Transformer ........................................................................................8 VA
Capacitor ..............................................................................12,5 µF 400 V
ELECTRIC MOTOR
Power output...............................................................0,24 KW (0,33 HP)
Supply voltage ..................................................................................230 V
Frequency..........................................................................................50 Hz
Absorbed power .............................................................................330 W
Absorbed current..............................................................................1,8 A
Capacitor.........................................................................................12,5 µF
Motor revolutions ..................................................................1˙350 r.p.m.
Intermittent service..............................................................................S 3
Insulation class ........................................................................................F
HYDRAULIC PUMP
Pump flow rate - P10 ...............................................................2,75
Working pressure ..........................................................2 MPa (20 bars)
Max pressure .................................................................4 MPa (40 bars)
Working temperature range ............................................–20° C +80° C
Oil type..............................................................OIL FADINI A15 by AGIP
Shaft rotation ..............................................................................max. 95°
Static weight.....................................................................................58 Kg
Max. rated torque......................................................................185,2 Nm
Aluminium beam .................................................................................4 m
Opening time..........................................................................................5 s
Closing time. ..........................................................................................5 s
Protection standards......................................................................IP 557
Pedestal colour ....................................................RAL 1018 yellow/zinc
Duty cycle: 5 sec. opening - 30 sec. dwell - 5 sec. closing.
Time of one complete cycle................................................40 seconds.
Complete cycles - "Opening-Dwell-Closing".........................No. 90/h
No of cycles per year with 8 hours' service a day ..........No. 262˙000
3
= 1˙400
l
4
240
/min.
l
1 - LEVEL BAR COMPLETE WITH BOLT, FERRULE AND FIXING NUT
2 - FOLDING JOINT. IT IS MADE UP OF FITTING END PART,
LOCKING NUT AND SCREW
3 - HORIZONTAL SECTION OF THE BEAM
4 - VERTICAL SECTION OF THE BEAM
5 - FERRULE, SCREW AND NUT FOR FIXING TO THE LEVEL BAR
6 - BRACKET, PIN AND SCREWS FOR FIXING TO THE HOUSING
7 - PLASTIC BUSHING
8 - ADJUSTMENT AND NUT
9 - WASHER AND NUT TO LOCK ADJUSTMENT TO FIXING
BRACKET
10 - HOUSING
The oil-hydraulic traffic barrier is also available in a
version with articulated arm. This is possible by means of some
parts specially designed to this purpose, easy to fit and reliable,
Pic. 19.
It is recommended to do some tests before finally fixing the
equipment, ie. make sure that the total height from ground level
to top of vertical section does not exceed the space between
ground and ceiling. Part. No. 2, folding joint, must be at least 10
cm lower than ceiling level Pic. 19.
The total available lenght, ie. the sum of the two beam sections,
is no more than 3 meters.
70
240
DOOR SIDE
FIXING
BASE PLATE
ø 14
ø 40
35 x 35
FIXED
PEDESTAL
PIC. 20
1 1
Advertisement
