Channel Settings - Philips 32PFL3007H/12 User Manual

Channel settings

Automatic install
When the TV was switched on for the first
time, a full installation of channels was
performed. To change your language,
country and reinstall all available TV channels,
you can run this full installation again.
Start installation
1. Press .
2. Select [Setup] > [Search for channels] >
[Reinstall channels], then press OK.
The Country menu is displayed.
3. Select your country, then press OK.
4. Select your network, then press OK:

[Antenna]: Access free-to-air antenna
or digital DVB-T channels.

[Cable]: Access cable or digital DVB-C
channels.
5. Follow the onscreen instructions to select
other options, if any.
The start menu for channel search is
displayed.
6. Start channel search:

If your channel service provider
instructs you to change settings, select
[Settings], then press OK. Follow the
service provider's instructions to
complete the installation.

Otherwise, select [Start], then press
OK.
7. Once the channel search is complete,
select [Finish], then press OK.
Tip: Press LIST to see the channel list.
Note: When digital TV channels are found,
the list of installed channels may display
empty channel numbers. You can rename,
reorder or uninstall these channels.
Install analogue channels
You can search and store analogue TV
channels one by one.
Step 1: Select your system
Note: Skip this step if your system settings
are correct.
1. While you watch TV, press
2. Select [Setup] > [Channel settings] >
[Channel installation].
3. Select [Analogue: Manual antenna
installation] > [System], then press OK.
4. Select the system for your country or
region, then press OK.
Step 2: Search and store new TV channels
1. In the [Analogue: Manual antenna
installation] menu, select [Find channel],
then press OK.
2. Find the channel:

If you know the channel frequency,
enter it with the Navigation buttons or
Numeric buttons.

If you do not know the channel
frequency, search for the next
frequency that has a strong signal.
Select [Search], and then press OK.
3. After you have found the correct channel,
select [Done], then press OK.
4. Select [Store as new channel], then press
OK to store the new TV channel.
Note: If the reception is poor, reposition
your antenna and repeat the procedure.
.
EN 27