Update Channel List - Philips 32PFL3007H/12 User Manual

Philips 3000 series lcd tv 32pfl3007h 81 cm (32") hdtv dvb-t/c with digital crystal clear
Hide thumbs Also See for 32PFL3007H/12:
Table of Contents

Advertisement

Install digital channels
If you know the channel frequency of the
channels you want to install, you can search
and store digital channels one-by-one. For
best results, contact the service provider.
1. Press
.
2. Select [Setup] > [Channel settings] >
[Channel installation].
3. Select [Digital: Reception test] > [Find
channel], then press OK.
4. Press the Numeric buttons to enter the
channel frequency.
5. Select [Search], then press OK.
6. When the channel is found, select [Store],
then press OK.
7. Press
to exit.
Note: If your cable provider does not
provide you with a specific symbol rate value
for DVB-C channels, select [Automatic] in
[Symbol rate mode].
Fine-tune analogue channels
If the reception of an analogue TV channel is
poor, you can fine-tune the TV channel.
1. Press
.
2. Select [Setup] > [Channel settings] >
[Channel installation].
3. Select [Analogue: Manual antenna
installation] > [Fine tune], and then press
OK.
4. Press
or
to fine-tune the channel.
5. When you have selected the correct
channel frequency, select [Done], and then
press OK.
6. Select an option, then press OK.
[Store current channel]: Store the
channel as the current channel number.
[Store as new channel]: Store the
channel as a new channel number.
EN
28

Update channel list

When the TV was switched on for the first
time, a full installation of channels was
performed.
By default, when there are changes to these
channel lists, the TV updates them
automatically. You can also switch off the
automatic update or manually update the
channels.
Note: If you are prompted to enter a code,
enter '8888'.
Automatic update
To add or remove digital channels
automatically, leave the TV in standby mode.
The TV updates channels and stores new
channels everyday. Empty channels are
removed from the channel list.
Switch off the channel update message
If a channel update is performed, a message
is displayed at startup. You can switch off this
message.
1. Press
.
2. Select [Setup] > [Channel settings] or
[Satellite settings].
3. Select [Channel installation] > [Channel
update message].
4. Select [Off], then press OK.
To switch off automatic updates
In the [Channel installation] menu, select
[Automatic channel update] > [Off].
Update channels manually
1. Press
.
2. Select [Setup] > [Search for channels] >
[Update channels], then press OK.
3. Follow the onscreen instructions to
update the channels.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents