Making Calls With One-Touch Dialing - Sony SSP-SS964 Operating Instructions Manual

Note
Do not allow more than 20 seconds to elapse between each step of the
procedure.
Tips
• If you have entered a wrong number in step 3 and have not pressed
(VOL/PGM) (step 4) yet, just turn Jog Dial down to erase it. Then, enter the
correct number.
• You may press Jog Dial instead of (VOL/PGM) in step 4.
To store a number to be dialed via Private Branch Exchange
(PBX)
Before entering a phone number in step 3 on page 16, do as follows:
1
Enter the outside line access digit (e.g., 9).
2
Press (REDIAL/PAUSE).
To change a stored number
1
Press (VOL/PGM).
2
Press one of the ONE-TOUCH DIAL buttons ((A) to (C)).
The current number appears on the display.
3
Turn Jog Dial down to erase the current number.
4
Enter a new number.
5
Press (VOL/PGM).
Note
You can replace the stored number with a new number, but you can't just erase
it.

Making calls with one-touch dialing

1
Press (TALK/FLASH) and wait until "TALK" appears on the
display.
2
Press one of the ONE-TOUCH DIAL buttons ((A) to (C)).
The phone number stored on the one-touch dialing button
will appear on the display and will be dialed.
To check the phone number before one-touch dialing
When not conversing with an outside caller with the handset, press
one of the ONE-TOUCH DIAL buttons ((A) to (C)).
The number stored for that button appears on the display for five
seconds. To dial the number, press (TALK/FLASH) while the number is
displayed.
17
Telephone Features
EN