Table of Contents
Advertisement
Switch all outputs to input 1, set all volumes to 99
•
Restore the saved configuration once the paging is done
•
The macro for this sequence is:
[M,S,1]
{[BA,1,0][BL,99,0]}
[M,R,1]
Memory Edit
Memory edit allows the user to modify the contents of a memory slot. To do
this, send the memory edit command then send a group command:
[M,E,n]
{ [ ] [ ] [ ] [ ] }
n is the memory slot to edit
For this code format, note:
These commands will be stored in the memory location, but will not be
•
executed.
The memory edit function only accepts switch commands, including
•
volume & tone commands.
The commands can contain a time parameter, as used for audio
•
transitions.
While memory edit command is active invalid code inside a group
•
bracket
Commands after the closing bracket will be treated as normal
•
commands.
If no opening bracket is detected right after invoking the memory edit
•
command, the program will exit the memory edit function without
saving anything to the designated memory location.
Setup Protocol
Setup commands have 3 parameters:
[S,x,n]
S
invokes the Setup function
The table below lists values for
x
L
0
{ }
will be ignored.
x
n
Led OFF
DOC42-00027-C Integrator's Guide.doc
n:
and
Setup function
22
Advertisement
Table of Contents
